Home > HARDWARE > BUILDING MATERIALS > JOIST HANGERS & CONNECTORS
Choose a sub category:
JOIST HANGERS FRAMING ANGLES/ANCHORS MENDING PLATES
NAIL PLATES POST ANCHORS / CAPS FENCE BRACKETS
INSULATION SUPPORTS STRAPS PLYWOOD CLIPS
FOUNDATION ANCHORS BRICK/WALL TIES MISC CONSTR HARDWARE
Sort By:
Go
Page of 1
STRP-TIE HOLDOWN GALV 26-1/8IN DECK TENSION TIE ZMAX 14GA    JOIST HANGER ZMAX 18GA 2 X 8IN
The STHD is an embedded strap-tie holdown offering high-loads in both wood and cold-formed steel construction. When installed on the forms with the StrapMate? strap holder or other holding device, the unique design of this cast-in-place strap-tie holdown delivers enhanced stability before and during the pour to help prevent both parallel and perpendicular movement. This results in accurate positioning of the strap and reduced possibility of spalling. DTT tension ties are safe, cost-effective connectors designed to meet or exceed code requirements for deck construction. These versatile DTT connectors are also load-rated as a hold-down for light-duty shearwalls and braced-wall panel applications. The LUS is an easy to install, economical hanger designed for common lumber sizes. This widely used hanger features double-shear nailing that distributes the load through two points on each joist nail for greater strength. This allows for fewer nails, faster installation and the use of all common nails for the same connection.
BEARING PLATE HDG 3GA 5/8X3IN
The BPS is designed to provide a greater bearing surface than standard-cut washers and help distribute the load at critical connections. This bearing plate features a slotted hole that allows for adjustability to account for bolts that are not in the middle of the sill plate. The BPS offers increased flexibility while meeting the latest code requirements for 2 x 4 and 2 x 6 walls.